HowTo Show System Information - 8xxx
- Accessing from Cable Box
-
Press and hold Select button (A). Once
the transfer light (B) starts blinking,
release (A). Press the INFO button (C).
You should now be in DIAG mode, use the
arrows (D) to cycle through the menus.
When done, press EXIT (E).
(Note: You can press Select button (A)
while viewing diags to make them
translucent so you can see the picture
too)
- Accessing from Remote
-
Another way to enter DIAG mode is to use
the remote. Hold down PAUSE (F) for more
than 10 seconds, wait for the transfer
light (B) to start blinking, then press
PAGE+ (G). Use PAGE+ / PAGE- (H) to
cycle through the menus. Hit EXIT (I)
when done.
|
|
|